SEARCH

1/09/2021

ACT (RS) ABB Loco (English) (21. HOW TO CHANGE THE CAB)

How To Change The Cab 

 Single Unit 

1. Apply loco brakes by SA-9 

2. Open ‘DJ’ by pressing BLDJ at ‘OFF’

3.Lower the panto by pressing ZPT at ‘DN’Operate 

4. BL key from ‘D’ to ‘off’ and remove it (CE will remain ON for 10”). P/ZRTI-BSL 43 

5.Set automatic brake controller to position ‘Neutral’ and then remove handle 

6.Release direct brake handle. 7.Go in another cab and energize it in “Normal” way. 

Note: 

* If BL key is taken ‘OFF’ without opening DJ and lowering panto , loco will be shutdown as emergency shutdown will initiate on loco. 

* During normal driving if BL key is kept ‘OFF, emergency brakes will get applied as emergency shutdown will initiate on loco.

*After moving the key switch ‘BL’ to position ‘O’, the MCE remains active for 10 minutes. The change of driver’s cab should take place during this time, If the MCE has to be restarted, it takes longer to set up the locomotive because Peripheral tests have to be carried out

.

Disclaimer: The Information/News/Video provided in this Platform has been collected from different sources. We Believe that “Knowledge Is Power” and our aim is to create general awareness among people and make them powerful through easily accessible Information. NOTE: We do not take any responsibility of authenticity of Information/News/Videos.

A Center Of Information & News For Railway Employee By Information Center

Followers